Firmware for Maxu MAKCU DMA

Here is a detailed and clear instruction on the firmware of your controller. MAKCU. Follow these steps strictly in order to ensure that your device is working properly. DMA setup.

, Preparing for the firmware

For secure firmware and to prevent the creation of temporary files, all actions are performed strictly from your second (technical) PC..

1. Download the AIO Tool: Get the current version of the tool here.
2. Launch: Open the program. Give it the option to automatically update to the latest version.
3. Cables: You will need one USB cable for the firmware process. Important: before starting the firmware process disconnect all cables from the MAKCU device.

, The firmware process (Flash Steps)

The firmware is divided into two stages. Never try to flash the device from the main gaming PC!

Stage 1: Stitching the left side

1. Hold it down The LEFT button on the device.
2. Hold down the button and connect the USB cable to LEFT USB port.
3. The following message should appear in the AIO Tool program: "MCU connected in flash mode". This confirms that the device has entered firmware mode.
4. Click the button Flash Left in the program and wait for the process to complete.
5. When finished, disconnect the USB cable from the left port.

Stage 2: Right Side Firmware

1. Hold it down The RIGHT button on the device.
2. Hold down the button and connect the same USB cable to THE RIGHT USB port.
3. Click the button Flash Right in the program and wait for completion.

⚙️ Configuring drivers and COM port

So that your KMBox or the controller MAKCU If they were detected correctly by the system, follow these steps:

1. CH343 Driver: Download the archive with the driver, unzip it, right-click on the installation file and select Install.
2. Device Manager: On the second PC, open the Device Manager and find the Ports (COM and LPT) section.
3. Configuring the COM port:
   • •Find the device signed as CH343.
   • •Right-click -> Properties -> Port Settings tab -> Advanced button.
   • •Set the COM port number below 10 (for example, COM3 or COM4). Click OK.
4. Restart: If the AIO Tool has been opened, close it. Disconnect and reconnect the cable to the leftmost port of the device to reboot.

, Final setup and test

Now that the firmware is complete, you need to properly connect the hardware to play the game. PUBG or Rust.

• •Connecting cables:
  • •Leftmost cable: connect to your the main (gaming) PC.
  • •Medium cable: connect to secondary (technical) PC.
  • •Rightmost cable: connect your gaming mouse.
• •Testing:
  • •Restart the AIO Tool and click "TEST".
  • •If your cursor on the main monitor makes a sharp "teleport", it means that everything is working correctly and the setup is completed successfully!

Need some help? If you have any questions about work DMA cards or setting up the software, you can always get advice by writing to us in Telegram.: https://t.me/dmalabs.